Sorry for all of the questions, figure it's best to ask the experts instead of fumbling along on my own!
Any ideas on the size of arbor spacers and quantities that were included with the factory arbors? I may have answered my own question; a May 1962 MFC manual downloaded from someplace indicates the following: 2 - 2", 1 - 1", 1 3/4" and 1 1/2". Seem correct or should I pick up a variety of other sizes?
My mill (MFB) did not include an original vise. I'm not hung up on having an original, but can someone tell me the tape measure height from the table to the top & bottom of the jaws? I'm looking at a Shars 3" swivel vise that is about 4 1/4" from table to top of jaws, 3 1/4" to the bottom of the jaws. The mill is somewhat cramped for vertical space, would hate to spend $80 on an unusable vise!
Last question (for now), can someone email me (bghansen08@gmail.com) a photo of the kick-out detail that was on the table? I'll fab up something that'll work, just easier to work off the photo of an original.
Thanks again for all of the help! Bruce